Hi,
We are getting the following error when trying to run the proc made in uber_subject.py:
** warning: removing first 2 TRs from beginning of each run
→ the stimulus timing files must reflect the removal of these TRs
– will use min outlier volume as motion base
– tcat: reps is now 91
– volreg: using base dset min_outlier_volume+orig
++ volreg: warp and align to isotropic 3.5 mm tlrc voxels
– applying anat warps to 1 dataset(s): efgre3d_scan_15
– masking: group anat = ‘TT_N27+tlrc’, exists = 1
++ updating polort to 2, from run len 182.0 s
** unusable token, bad floats : ÿþ5
I think it is related to our stimulus timing files, but for the life of my I can’t figure out what.
This is part of the text from output.cmd.ap:
** unusable token, bad floats : ��5#8#:#8#
line = ��5#8#:#8# #6#8#:#8# #1#1#0#:#1#0# #1#3#4#:#6#
** A1D: failed to read data file /home/data/A100219/To3dAnalysis/A100219attnBLnew.1D
** failed to load stimulus timing file ‘/home/data/A100219/To3dAnalysis/A100219attnBLnew.1D’
** unusable token, bad floats : ��1#4#:#8#
line = ��1#4#:#8# #4#8#:#6# #9#0#:#6# #1#0#0#:#8#
** A1D: failed to read data file /home/data/A100219/To3dAnalysis/A100219attnBRnew.1D
** failed to load stimulus timing file ‘/home/data/A100219/To3dAnalysis/A100219attnBRnew.1D’
** unusable token, bad floats : ��*#
line = ��*# #
** A1D: failed to read data file /home/data/A100219/To3dAnalysis/A100219attnErrornew.1D
** failed to load stimulus timing file ‘/home/data/A100219/To3dAnalysis/A100219attnErrornew.1D’
** unusable token, bad floats : ��2#6#:#6#
line = ��2#6#:#6# #7#8#:#1#0# #1#2#4#:#8# #1#5#6#:#6#
** A1D: failed to read data file /home/data/A100219/To3dAnalysis/A100219attnTLnew.1D
** failed to load stimulus timing file ‘/home/data/A100219/To3dAnalysis/A100219attnTLnew.1D’
** unusable token, bad floats : ��6#:#6#
line = ��6#:#6# #3#4#:#1#0# #1#4#4#:#8# #1#6#4#:#8#
** A1D: failed to read data file /home/data/A100219/To3dAnalysis/A100219attnTRnew.1D
** failed to load stimulus timing file ‘/home/data/A100219/To3dAnalysis/A100219attnTRnew.1D’
– consider use of ‘-test_stim_files no’ if files are OK
** script creation failure for block ‘regress’
** failed command (create_script):
Any help would be greatly appreciated!!!